1、此沼氣火炬結構是半內燃式，防風。故障熄火，火炬處于欠壓保護狀態。達到燃燒條件時，沼氣火炬又自動運行點燃了。

1. This biogas torch structure is semi internal combustion type, windproof. Fault shutdown, the torch is in under voltage protection state. When the combustion conditions are reached, the biogas torch automatically runs and ignites again.

2、火炬壓力自動檢測：火焰控制系統在供氣管路上安裝有三個壓力檢測器，分別按現場供氣壓力情況設定低壓、中壓和高壓三個參數。

2. Torch pressure automatic detection: The flame control system is equipped with three pressure detectors on the gas supply pipeline, which set low pressure, medium pressure, and high pressure parameters according to the on-site gas supply pressure situation.

1）當供氣系統中壓力達到中壓時，火炬自動開機，實現自動點火、啟動火炬燃燒。

1) When the pressure in the gas supply system reaches medium pressure, the torch automatically turns on, achieving automatic ignition and starting torch combustion.

2）當供氣系統中壓力下降至低壓值時，火炬自動停機。

2) When the pressure in the gas supply system drops to a low pressure value, the torch automatically shuts down.

3）當供氣系統中壓力繼續升高達到高壓時，火炬的二級火自動開啟。

3) When the pressure in the gas supply system continues to rise and reaches high pressure, the secondary flame of the torch will automatically start.

3、火炬在燃燒頭內部安裝有火焰檢測電出彩，當火炬熄火時，檢測電出彩發出信號，信號被測控系統的微電腦控制器接收，經多次確認熄火信號正確后，微電腦控制系統發出指令，火炬燃燒系統自動停機，并同時發出報警信號。

3. The torch is equipped with a flame detection electrode inside the combustion head. When the torch is turned off, the detection electrode sends a signal, which is received by the microcomputer controller of the measurement and control system. After multiple confirmations that the extinguishing signal is correct, the microcomputer control system issues a command, and the torch combustion system automatically stops and sends an alarm signal at the same time.

4、此沼氣火炬不僅可以手動開機、停機，還實現了自動開機、停機。

4. This biogas torch can not only be manually started and stopped, but also automatically started and stopped.

火炬安裝結束后應進行火炬試車

After the installation of the torch is completed, a torch test should be conducted

1．檢查火炬供電系統接線是否良好。

1. Check if the wiring of the torch power supply system is in good condition.

2．檢查火炬鼓風機旋向是否正確。

2. Check if the rotation direction of the torch blower is correct.

3．檢查沼氣供氣系統是否密封,有無泄露。

3. Check if the biogas supply system is sealed and if there are any leaks.

4．檢查火炬供氣電磁閥組運行是否正常。

4. Check if the torch gas supply solenoid valve group is operating normally.

本文由沼氣脫硫友情奉獻.更多有關的知識請點擊:http://www.szzcsj.com真誠的態度.為您提供為的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is contributed by the friendship of biogas desulfurization For more information, please click: http://www.szzcsj.com Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.